- Tanks come with everything
installed on them:
- Well Manager UL Listed control
panel for 1 or 2 wells built to
industrial standards installed on the
tank – end or side mount available
- All penetrations water tight
- Low water cut off protects pressure
pump
- Flow Detector protects well pump
- Timing control protects well from
overpumping
- Everything can be unbolted from
tank
- Tank level controls pass NSF 61
Potable Water
- Pipe & Fittings NSF 61
- StaRite 10 gpm pump with 5 yr
warranty provides great pressure
- 230V pumps draw 5.5 amps; 115
volt units draw 11.0 amps
- All but 3” of stored water usable
- Overfill Shutoff with manual reset
stops overflows
- 1” inlet & outlet
- All field wiring connections by wire
nut in one box
- Service or replace pump without
draining tank
- Installation, set up and
maintenance Manual
- Many options – Radon, odor removal see back
Rectangular tanks permit larger storage capacities in less space than
round tanks. Several tanks can be assembled to provide generous
storage even in a crawl space.
When you do not have a lot of height, these horizontally configured
systems are the answer. They measure 37” W x 71.25” long x 38” High
with everything mounted on the tank. In a pinch, everything unbolts so
you can put them through small openings 26.5” x 37” and then
reassemble the system when you get it in place.
Increase Storage by Adding Tanks
Matching storage tanks are only 26.5” to the top of the lid. Connecting
manifolds are available.
Spray Boom Fill
A Spray Boom Fill can reduce or remove sulfur odors, and gasses like,
H2S, Oxygen, Air, CO, CO2, Methane, natural gas and Radon without
chemicals or additional mechanical equipment. This reduces the space
required for treatment equipment and uses less energy than other
treatment methods.
Using a Spray Boom Fill for odor, flammable gas or Radon removal
requires the addition of a power vent to the exterior of the building.
|
